Before Fitting The Turntable; Fitting The Turntable; Fitting The Turntable Mat; Attaching The Head Shell - Technics SL-1200GR Manuel D'utilisation

Before fitting the turntable

1
Remove the magnet cover from
the turntable.
z There is a magnet and its cover on the
back side of the turntable.
Remove the magnet cover before fitting
to the main unit.
Back side of the turntable
Magnet
Attention
z Keep any magnetic-sensitive object such as
a magnetic card and watch away from the
magnet.
z Prevent the turntable from hitting the main
unit or falling off.
Prevent dust or iron powder from adhering
to the magnet on the back side.
z Do not touch the fixing screws (three
locations) of the turntable. The rating
performance cannot be guaranteed if they
are out of position.

Fitting the turntable

2
Slowly set the turntable on the
center spindle.
To remove the turntable
„
As shown in the

figure on the right,
set your fingers in
the two holes on
the turntable, hold
the center spindle
down and remove
the turntable
upward.
Attention
z Be careful when handling the turntable, as it
is heavy.
z Keep your fingers from being caught.
z Wipe off fingerprints or dirt with a soft cloth.
Magnet cover
Fixing
screw

Fitting the turntable mat

3
Lay the turntable mat on the
turntable.

Attaching the head shell

4
Fit the head shell with the
cartridge into the tone arm.
Keep the head shell horizontal
and tighten the locking nut.
z Be careful not to touch the stylus tip.
Locking nut
Head shell

Attaching the balance weight

5
Attach the balance weight to the
rear of the tone arm.
Balance weight
Auxiliary weight
z Attach the included auxiliary weight to the
rear of the tone arm according to the weight
of your cartridge.
For adjustable cartridge weight ranges, see
"Applicable cartridge weight range". (
Note
z The inside of the balance weight is greased.
27)

15
(15)
English