Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
On and Off
By feeding the regulator it will show automatically the following turning on series
-
Device name ()
-
Internal software version composed by 2 digit separated by a point (.)
-
Device settings, composed by 2 digits ()
-
Load of memorised parameters ( intermittent for a few seconds)
-
Valid data recognising in memory ()
The regulator is in normal operation when it shows on the display the temperature of the sensor.
By pressing 3 seconds button
IOC-S are deactivated and the security functions and antiblocking of circulators are active. By pressing the same button for 3 seconds, the
device returns to the normal operation phase.
Setting and changing the parameters
When it is shown the parameter of setting during the (Cxx), this indicates that the regulator is prepared to control a hydraulic system. To
set the parameter you must access to the INSTALLER MENU as shown below, wait the automatic activation before entry again to the same
MENU, and verifying the new adjust of values of the other parameters.
To access to the INSTALLER MENU press at the same time
digits password. Use
and
three digits preview.
If you do not press any button for 3 seconds or if you insert a wrong password the operation stops and the system goes to the normal state.
Supervision password is 007, non-modifiable.
IMPORTANT: modification of parameters of USER MENU can do the regulator to not be adequate and this must be made only and exclusively
by a qualified technician.
When we access to the INSTALLER MENU, the display will show the symbol of the first parameter. In this moment it is possible:
-
To move inside the list of parameters by using buttons
-
To choose a parameter with the button
pressing buttons
By pressing button
repeatedly, you can confirm the data and you are able to pass to the following parameter.
All the modified data are memorised after 5 seconds from the last pressed button. Then, the device will return to the normal operation state.
Below there is a table of parameters of programming for the INSTALLER MENU in every setting.
Symbol
Device setting
Flowmeter setting
High temperature alarm thermostat
Security thermostat
De-icing activation thermostat
Anti-condensation thermostat
Circulator C1 thermostat hysteresis
Valve thermostat hysteresis (sensor 1)
Circulator P2 thermostat hysteresis
Anti-condensation thermostat hysteresis
Valve thermostat hysteresis (sensor 2)
Timer antiblocking circulator
Timer circulation activation after antiblocking
Security thermostat enable (1=active)
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
the device goes to the STAND BY mode with the indication on the display. All the outputs of the card
to decrease or increase the value and then finish by pressing button
,showing automatically the value memorised and making possible the modification by
(increase value) and
(decrease value).
Description
and
until we see the value flashing (for 5 seconds) and insert the 3
(forward) and
(back).
U.m.
--
--
°C
°C
°C
°C
°C
°C
°C
°C
°C
h
s
---
22
to confirm every one of the
Min
Max.
Manufacture
1
6
0
1
80
99
80
90
4
8
25
85
1
20
1
20
1
20
1
20
1
20
1
255
0
99
0
1
6
0
90
80
5
40
4
4
4
4
4
168
20
0
KIT-2
Publicité
Table des Matières
