Bronpi KIT-2 Instructions D'installation, D'utilisation Et D'entretien page 20

Red
External interface
INPUTS
OUTPUTS
User interface HID FIRE BASIC
It is the device that allows the user to set and manage the module through the communication with the card IOC-S.
This device is always accessible to the user in order to be consulted and regulated in the most simply way. It can be away from the KIT-2 or
connected to another HID FIRE BASIC delivered as a separated accessory (see chapter "Remote interface HID FIRE BASIC").
Ref Symbol
1
2
3
4
5
6
7
8
9
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
CONNECTORS
13(L) 12(Gnd) 11(N)
HID
S1
17 – 18
19
20-22
21
1(NO) 2(NC) 3(N) 4(GND)
5(L-on) 6(N) 7(Gnd)
8(L-on) 9(N) 10(Gnd)
14(NC) 15(C) 16(NO)
Signing Circulator (C1) heating chimney working.
Signing Circulator (C2) installation working.
Signing diverter valve is active.
Signing disabled boiler.
Button for the selection of parameters, manual test diverter valve.
Button to reduce values, go back parameters in the fitter menu and manual test Circulator C1.
Button to increase values, step forward parameters in fitter menu and manual test Circulator C2.
Button to on / off regulator.
3 digit display to see temperature, adjusted parameters, activation of flow detector and system state.
FUNCTIONS
Power supply
Communication with HID FIRE
BASIC
S1
Flow detector /S2
Flowmeter
TA/S3
NU
Geared diverter valve
CIRCULATOR (C1)
CIRCULATOR (C2)
Consensus boiler (AUX)
Functions
21
NOTES
230Vac-50Hz
Connections not polarized to 2
cables
NTC 10K@25°C
ON/OFF-NTC 10K
5Vac
ON/OFF-NTC 10K
Tension output in switching
230 Vac
Output in tension 230Vac
Output in tension 230Vac
Free volt switching contact
KIT-2