Bronpi KIT-2 Instructions D'installation, D'utilisation Et D'entretien page 14

Interconnected module between installations with an open-close expansion vessel and a close vessel (version with an electronic
INTRODUCTION
Dear client, we thank you for your confidence and we congratulate you for choosing this hydraulic module.
ADDRESSEES
This manual is addressed to:
- The installation designer
- The fitter
- The user
- The maintenance technician.
GENERAL WARNINGS
• This manual makes reference to installation, use and maintenance instructions of the hydraulic module KIT-2. This document is an
integrant and essential product part and it must be delivered to the final client, who will keep it in case of any future necessity.
• Read carefully these instructions before the installation and start up of the module.
• The module is delivered protected with a necessary packing for the transport. After removing the packing you must check the proper
state of the equipment and the whole supply. In the case your product is not corresponding to the one requested or some components
are missing, please contact your provider.
• Installation, start-up, maintenance and repair must be made by a qualified fitter who follows the local current rules and dispositions.
• In case of not complying with these instructions during the operation and control procedure, personal injuries or environmental
pollution may occur.
• The company reserves the right to modify the technical characteristics of the product without prior notice.
USE AND SERVICING ADVISING
• Installation and maintenance operation of the product must be made by qualified fitters and following the current rules.
• In order to guarantee the proper operation of the equipment it is important to carry out maintenance tasks at least once a year for an
authorised fitter or enterprise.
• In case of any anomalous work, please contact a specialised fitter or a technical service.
• Components inside the module can only be changed by original components.
• Any intervention in the components or internal parts of the equipment and the pieces involve the end of the responsibility of the
manufacturer.
SECURITY ADVISES
Before the intervention in the module:
- Make sure that the electrical supply is off.
- Make sure that inside the
module there is not a high
temperature/pressure flow
and that all parts have a low
temperature.
TECHNICAL SPECIFICATIONS
KIT-2 is a system fully-automatic of
hydraulic exchangers that allows to
manage the domestic heat from two
alternative sources of energy, whose
circuits are hydraulically separated.
The most typical application is an
exchanger in a domestic heating
between a heating chimney and a
gas/gas oil boiler as shown in the
following image:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
KIT-2
control included IOC-S + HID FIRE BASIC)
15 KIT-2