Safety Instructions; Description Of Parts; Normal Operation - Peach PS500-40 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9

Safety Instructions

GB
Read and follow all instructions carefully.
Keep these instructions for future reference.
Always turn off and unplug the machine
before moving, cleaning or anything other
than normal operation. Otherwise serious
injury may result. Clean shredder with a
damp cloth, using a mild soap and water
solution.
Do not use abrasives or solvent-based
cleaners.
Turn the power switch off before removing
the waste bin 6 . It is advisable to discon-
nect the power cord before opening the
shredder.
This product should never be placed near
a radiator or other heat source.
Do not allow anything to rest on the power
cord. Do not place the power cord
where people may walk on it.
Do not attempt to service this product
yourself, as opening or removing covers
may expose you to the risk of injury. Also,
doing this will void the shredder's warranty.
Unplug this product and contact technical
support if:
– The power cord or plug is damaged
or frayed.
– Liquid has been spilled on the product.
– The product has been exposed to rain.
– The product does not operate normally,
even when the operating instructions
are followed.
– The product has been dropped, or the
casing has been damaged.
This shredder should be operated only
with an operator in attendance.

Description of parts

AUTO / OFF / REV switch
LED "POWER"
LED "OVERHEAT"
Cutter opening for CD
Handle
Waste bin
Transparent window
Bin for CD
Mains plug
Paper shredder setup
Mount the shredder correctly on the basket
6 .
Connect the power cord
230 volt AC outlet.
It is normal for residual lubricant in the
motor to burn off during the rst several
extended uses of your shredder. Should
you notice a slight burning odor or the
presence of small wisps of smoke during
the rst several extended uses, you may
continue using the shredder. If either
symptom continues to occur after repeated
use, please contact technical support for
assistance.

Normal Operation

Move the switch 1 to the "AUTO" position,
the green LED "POWER" will light up.
Insert paper to activate. The shredder
starts automatically and will stop as soon
as all the paper has gone through.
The shredding capacity is 10 sheets
(80g/m
) or 1 CD / credit card. However,
2
you should shred only one type of these
items at a time to avoid causing an
overload.
Never attempt to shred sealed envelopes.
Doing so may damage the shredder.
Always remove and unfold envelope
contents completely before attempting to
shred. NEVER shred envelopes, labels or
anything with glue or any sticky substance
as this will lead to paper jams.
Do not shred any wet paper, carbon paper,
or vinyl bags. The waste will stick in the
cutter and may lower the shredding
performance.
Although the shredder can safely shred
staples and paper-clips, you should remove
them if possible. Industrial staples must be
removed.
any standard
7

Publicité

Table des Matières
loading

Table des Matières