Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
Shredding CD / credit card
GB
Shred CD's by adding them to the separate
cutting opening 4 .

Paper Jam

If too much paper has been inserted, a jam
may result.
To clear the jam, empty the waste basket 6
rst and mount the shredder on the basket
again
Move the switch 1 to the "REV" (rewind)
position to clear the shredder of paper that
has not passed through properly.
If not all the paper can be cleared, set the
switch 1 to the "FWD" (forward) position to
help the remaining paper to pass through.
This procedure may be repeated several
times until the jam is cleared.
Overheat
The shredder is built for short periods of
use only. Continuous shredding should not
last more than 3 minutes, after which the
shredder should be allowed to cool down
for 60 minutes before continuing.
If the shredder is used continuously for
more than 3 minutes it will stop operating
and the red LED "OVERHEAT" 3 will light
up. In this case, set the switch 1 to the
"OFF" position. The shredder will not
resume its normal operation until the motor
has cooled down to a safe temperature.
This may take 60 minutes
Maintenance
It is recommended to lubricate the cutting
blade from time to time with Peach oil
paper PS100-00 or Peach Shredder oil
PS100-05. This will increase the working
life of the cutting unit.
Empty the waste bin Set the switch 1 to
"AUTO".
Run the oil paper (Caution: Do not open
the bag) through the shredder. Then let the
unit run backwards (switch 1 to "REV") for
about 10 seconds.
8
Peach oil paper PS100-00 and Peach
Shredder oil PS100-05 are available from
your dealer and in various online shops.

Publicité

Table des Matières
loading

Table des Matières