Virax GR2-12 Manuel D'utilisation page 31

Maintenance instructions
Ensure that the machine is disconnected before
carrying out maintenance or adjustments.
Hydraulic liquid level
(Hydraulic oil viscosity 10 or 20)
Loosen the filling cap to add hydraulic oil (loss through
the cylinder valve, remove all dirt in the vicinity of the
lid orifice). Remove all dirt around the filling orifice
before adding oil
Unscrew the drain screw before emptying all the used
dirty oil. If you wish to remove the entire hydraulic
cylinder from the main unit lower the slide to the lower
position, loosen the screws fixed to the piston and the
10 screws from the pump seat.
Lubrication
The lubricator for the roller shaft must be lubricated
once a month and each time the roller set is replaced.
Add lubricating grease to the pin bearings prior to
reassembling them.
Service and repairs
The service and repairs to this grooving machine must
be carried out by qualified technicians. If the machine
does not operate correctly it must not be repaired by
the user but by contacting the manufacturer for repair.
WARRANTY
The VAL96QC pipe cleaner is guaranteed for 2 years,
excluding parts subject to wear and tear.
Interventions or repairs by unauthorized workshops
will cancel any warranty
MAINTENANCE
MAINTENANCE
ENGLISH
31