Turning Power On/Off; Turning On The Main Power; Disabling Power On/Off Operations - Sharp PN-E601 Mode D'emploi

Caution
• Turn on the monitor first before turning on the PC or
playback device.

Turning on the main power

Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
When the main power switch is off, the monitor cannot be
turned on using the POWER button on the remote control unit.
Status of a power LED
Green lighting
Orange lighting
Green flashing
Caution
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
12
E
Turning Power On/Off
Power LED
Status of the monitor
Power on
Power off (Standby mode)
Input signal waiting mode
TIPS
• If the monitor is in the input signal standby mode and you
press the POWER button on the remote control unit, the
monitor enters standby mode.
• You can turn on/off the monitor by pressing the power
switch on the front panel of the monitor.
• Setting the SCHEDULE flashes the power LED alternately
in red and orange in standby mode.
nDate/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/
SET 20 09
CANCEL
1. Press , ,
time, and press
values.
2. Select SET and then press
• Be sure to set the date and time.
• The date/time setting screen will close automatically if no
operation is performed for about 15 seconds. The date
and time can be set using DATE/TIME SETTING from
the OPTION menu when the date/time setting screen
disappears.
TIPS
Set the date in "Year/Month/Day" order.
•
• Set the time on a 24-hour basis.
• The clock is maintained by the internal battery.
If you already set time but the date/time setting screen
•
appears when the power is turned on, the internal
battery is exhausted. Consult your SHARP dealer or
repair service contact for battery replacement.
Estimated service life of the internal battery: About 5
•
years (depending on the monitor condition)
Since the first battery was inserted at the factory, it may
•
be exhausted prior to the expected continuous operation
life.

Disabling power on/off operations

Power on/power off operations can be disabled in order to
protect the monitor from an accidental power off. Set the
ADJUSTMENT LOCK in FUNCTION menu to "2". (See
Operation guide.)
/ : :
/ 01 / 01 00 : 00
OK···[MENU]
or to select the date and
or to change the numerical
MENU .