Care And Maintenance - Hilti TE 60 Mode D'emploi

5. To begin chiseling, plug the power tool's supply
cord into the power outlet.
6. Set the desired chisel position.
NOTE After connecting the supply cord to the
electric supply, the power tool is always set to full
chiseling power.
NOTE To set the power tool to reduced (50%)
en
chiseling power, press the reduced-power button.
The chiseling power LED then lights. To reselect
full chiseling power, press the reduced-power
button again.
7. Position the tip of the chisel at the point where
chiseling is to begin.
8. Press the control switch fully.
7.2.5 Drilling without hammering (TE 60 ATC /
TE 60T ATC)
1. Turn the function selector switch until it engages
in the "Drilling without hammering" position. Do
not operate the function selector switch while the
motor is running.
2. Bring the side handle into the desired position
and check that it is fitted correctly and secured.
3. Plug the supply cord into the power outlet.
4. Position the power tool and drill bit at the point
where the hole is to be drilled.
5. Press the control switch slowly (drill at a low
speed until the drill bit centers itself in the hole).
6. Press the control switch fully to continue working
at full power.
7. Do not apply excessive pressure. This will not
increase the power tool's drilling performance.
Lower pressure extends the life of the insert tool.
7.2.6 Drilling without hammering (TE 60 /
TE 60T)
Drilling without hammering is possible when drill bits
with a special connection end are used. Drill bits of

8. Care and maintenance

CAUTION
Disconnect the supply cord plug from the power
outlet.
8.1 Care of core bits and metal parts
Remove any dirt adhering to the surface of the core
bits, the chuck and drive spindle and protect their
surfaces from corrosion by rubbing them with an oily
cloth from time to time.
28
Printed: 27.05.2013 | Doc-Nr: PUB / 5071058 / 000 / 00
this kind are available from Hilti. For example, when
the keyless quick-release chuck is fitted, smooth-
shank drill bits for wood or steel can be used to
drill without hammering. The function selector switch
must be set to the "Hammer drilling" position when
the power tool is used in this way.
7.2.7 Control switch lock 8
When chiseling, the control switch can be locked in
the "on" position.
1. Push the control switch lock above the grip for-
ward.
2. Press the control switch fully.
The power tool then operates in sustained mode.
3. To cancel sustained operating mode, slide the
control switch lock to the rear.
The power tool then switches off.
7.2.8 Mixing
1. Turn the function selector switch until it engages
in the "Hammer drilling" position.
2. Insert the quick-release chuck in the power tool's
chuck.
3. Insert the mixing paddle.
4. Check that the insert tool has engaged correctly
by pulling it.
5. Bring the side handle into the desired position
and check that it is fitted correctly and secured.
6. Plug the supply cord into the power outlet.
7. Position the mixing paddle in the container hold-
ing the substance to be mixed.
8. To begin mixing, press the control switch slowly.
9. Press the control switch fully to continue working
at full power.
10. Guide the mixing paddle carefully in order to avoid
splashing and spillage.
8.2 Care of the power tool
CAUTION
Keep the power tool, especially its grip surfaces,
clean and free from oil and grease. Do not use
cleaning agents which contain silicone.
The outer casing of the power tool is made from
impact-resistant plastic. Sections of the grip are made
from a synthetic rubber material.