Hilti TE 60 Mode D'emploi page 25

Power tool
Hammer drilling speed
Drilling speed without hammering
Single impact energy (50% power)
Single impact energy (full power)
en
Other information about the power tool
Chuck (TE 60 / TE 60 ATC)
Chuck (TE 60T / TE 60T ATC)
Protection class as per EN
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a
preliminary assessment of exposure. The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly increase the exposure level over the total working
period. An estimation of the level of exposure to vibration should also take into account the times when the
tool is switched off or when it is running but not actually doing the job. This may significantly reduce the
exposure level over the total working period. Identify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
Noise and vibration information (measured in accordance with EN 60745 2 6):
Typical A weighted sound power level (TE 60 /
TE 60T with ATC and AVR)
Typical A weighted sound power level (TE 60
/ TE 60T)
Typical A weighted emission sound pressure level
(TE 60 / TE 60T with ATC and AVR)
Typical A weighted sound pressure level (TE 60
/ TE 60T)
Uncertainty for the given sound level
Triaxial vibration values (TE 60 / TE 60T with ATC and AVR, vibration vector sum)
Hammer drilling in concrete, a
Chiseling, a
h, Cheq
Uncertainty (K) for triaxial vibration value
Triaxial vibration value for the TE 60 (vibration vector sum)
Hammer drilling in concrete, a
Chiseling, a
h, Cheq
Uncertainty (K) for triaxial vibration value
Triaxial vibration values (TE 60T, vibration vector sum)
Hammer drilling in concrete, a
Chiseling, a
h, Cheq
Uncertainty (K) for triaxial vibration value
22
Printed: 27.05.2013 | Doc-Nr: PUB / 5071058 / 000 / 00
h, HD
h, HD
h, HD
TE 60 / TE 60 ATC / TE 60T / TE 60T ATC
485/min
695/min
3.5 J
7.0 J
TE Y
TE T
Protection class II (double insulated)
110 dB (A)
107 dB (A)
99 dB (A)
96 dB (A)
3 dB (A)
9 m/s
8.5 m/s
1.5 m/s
18.5 m/s
14 m/s
1.5 m/s
18.5 m/s
17 m/s
1.5 m/s