Insert Tools, Accessories - Hilti TE 60 Mode D'emploi

Reduced (50%) power indicator (see section "Operation / hammer drilling / chiseling")
2.10 Items supplied as standard
1 Power tool with side handle
1 Depth gauge
1 Grease
en
1 Cleaning cloth
1 Operating instructions
1 Hilti toolbox
2.11 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 100V
Mains voltage 110-120 V
Mains voltage 220-240 V
Do not use extension cords with 1.25 mm conductor cross section.
2.12 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.

3. Insert tools, accessories

Hammer drill bits
Hammer drill bits
Breach bits
Breach bits
Percussion core bits
Percussion core bits
PCM diamond core bits
20
Printed: 27.05.2013 | Doc-Nr: PUB / 5071058 / 000 / 00
1.5 mm 2 mm
30 m
20 m 30 m
30 m
TE 60 / TE 60 ATC
TE 60T / TE 60T ATC
TE 60 / TE 60 ATC
TE 60T / TE 60T ATC
TE 60 / TE 60 ATC
TE 60T / TE 60T ATC
TE 60 ATC / TE 60T ATC
2.5 mm 3.5 mm
50 m
40 m
75 m
12...40 mm
6...32 mm
40...66 mm
40 mm
45...90 mm
50...90 mm
42...82 mm