Vermeiren Illico Manuel D'installation page 22

EN
NL
PL
CS
[9]
Prevent fingers getting entrapped by the
frame-cross locking system.
•
Push and hold the head section a bit
down at the front, with one hand. Push
with your other hand the support with
locking pin (32) aside to let the guide (31)
pass the pin. The location to push is
marked with a green dot.
•
Release the locking pin when the guide
has passed.
•
Lower the head-section end and place it
on its roller wheels.
[11]
•
Lift and turn the head section on the roller
wheels.
•
Remove the head section with motor and
cable.
•
Repeat this for the leg section.
32
CAUTION Risk of entrapment
31
[10]
•
Open the control box with the control-box
opener (see §4.1), by pressing the two
locking clips simultaneously.
•
Unplug the motor cables of head and leg
section, see §4.2.
[12]
•
Use the handset to fold the undercarriage
completely.
•
Unplug handset cable, see §4.2.
•
Close the control box.
•
Wind the power-supply cable on the
cable holder of the undercarriage.
•
Store all components on the transport
trolley, see chapter 3.
Installation manual
- 18 -
Illico
2018-07
Assembly and disassembly