Symbols On The Product - Husqvarna 525DEPS Manuel D'utilisation

21. Transport guard, bar
22. Combination wrench
23. Combination wrench, chain tensioner
24. Harness
25. Spark plug cap and spark plug
26. Shaft coupling
27. Impact guard
28. Dielectric chain oil
29. Two-stroke engine oil
30. Short shaft
31. Long shaft
32. Branch hook

Symbols on the product

Warning! This product is dangerous.
Injury or death can occur to the
operator or bystanders if the product is
not used carefully and correctly. To
prevent injury to the operator or
bystanders, read and obey all safety
instructions in the operator's manual.
Read the operator's manual carefully
and make sure that you understand the
instructions before use.
Use a protective helmet in locations
where objects can fall on you. Use
approved hearing protection. Use
approved eye protection.
Use approved protective gloves during
operation and maintenance. Use
protective boots or shoes with non-slip
soles. Use clothing of strong fabric and
of full length.
Fuel.
1480 - 008 - 10.08.2021
If the product touches or comes close to high-voltage power lines it could lead to death
or serious injury. Electricity can jump from one point to another by arcing. The higher
the voltage, the greater the distance electricity can jump. Electricity can also travel
through branches and other objects, especially if they are wet. Always keep a distance
of at least 11 m between the machine and high-voltage power lines and/or any objects
that are touching them, or obey minimum approach distance according to OSHA
1910.269(r). If you have to work within this safe distance you should always contact
the relevant power company to make sure the power is switched off before you start
work.
The operator of the product must ensure, while working, that no persons or animals
come closer than 15 meters.
Obey minimum approach distance according to OSHA 1910.269(r) and employer
guidelines.
Not for live-line work.
Chain oil.
Adjustment of the oil flow.
Primer bulb.
Choke.
Always keep your hands behind the
guard ring.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May
cause serious personal injury.
The rating plate shows the serial
number. yyyy is the production
yyyywwxxxxx year, ww is the production week
and xxxxx is the sequential num-
ber.
Direction of rotation, saw
chain.
3