Allmand MAXI-HEAT 1M BTU Manuel D'utilisation page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16
4. Install the ducting hose assembly onto the heater outlet
ring:
A. Align the pins on the connecting band (B, Figure 17)
with the J-slots on the heater outlet ring (D).
B. Push and turn the connecting band to lock the
ducting hose assembly in place.
17
After the ducting is installed, adjust the routing of the ducting
as necessary for your jobsite.
20
Air Inlet
Each air inlet can have 16" (406 mm) diameter ducting, but
it is not required. See Strap and Clamp Ducting and Slip-
Lock Ducting.
Operate the Engine
Start the Engine
1. Turn the engine control panel ON / OFF switch (D, Figure
6) to the ON position.
2. Push the ON button on the Deep Sea control module (E,
Figure 6) two times (2X).
Refer to the Deep Sea control module operator's manual and
engine operator's manual for further information.
Stop the Engine
1. Shut down the heater units. See Operate the Heater
Unit.
2. Push the OFF button on the Deep Sea control module.
3. Turn the engine control panel ON / OFF switch to the
OFF position.
Refer to the Deep Sea module operator's manual and engine
operator's manual for further information.
Block Heater
The engine has a frost plug style electric block heater, located
on the left side of the engine. Use a 3-prong, grounded
extension cord to connect the block heater to a 120-volt AC
power source.
Jump Start the Battery
Before you try to jump start the battery, make sure that
the battery cells are filled and the battery is not frozen or
damaged. Do not jump a frozen or damaged battery.
WARNING
Explosion Hazard
Trying to jump start a frozen or damaged battery could
result in death or serious injury. Do not try to jump start a
frozen or damaged battery.
1. Connect one end of the red jumper cable to the positive
(+) terminal on the booster vehicle battery. Then connect
the other end of the red jumper cable to the positive (+)
terminal on the heater trailer battery.
2. Connect one end of the black jumper cable to the
negative (-) terminal on the booster vehicle battery. Then
connect the other end of the black jumper cable to an
unpainted surface on the heater trailer engine.
3. Make sure that the jumper cables are not near any
moving parts of either engine.
4. Start the engine of the booster vehicle and let it operate
at idle for several minutes.
5. Start the engine of the heater trailer and let both engines
operate for several minutes.
www.allmand.com

Publicité

Table des Matières
loading

Produits Connexes pour Allmand MAXI-HEAT 1M BTU

Table des Matières