IKRA IGBS 1054 LI Manuel D'utilisation page 24

• The cutting tool continues to run after
the device is switched off.
• Turn off power before cleaning.
• Beware! Keep your fingers away from
the cutting area!
• Only switch on the device if your hands
and feet are away from the cutting tools.
• Remove all debris from the working area
before use and pay attention to such
debris while working!
• Turn the machine off before transporting
and wait until the blade stops moving.
Maintenance and cleaning should be
performed only when the machine is
turned off.
• Children and teenagers under 16 years
of age must never use this device!
• Never permit children or persons who
are not familiar with the operating in-
structions to use this device.
• Statutory regulations can restrict the
age of the operator.
• Be aware of third persons in the work
area.
• Use of the machine must be prevented is
people, especially children and house pets
are present.
• Only use the shear in daylight or suffi-
ciently bright artificial illumination.
• The clippers must be subjected to regu-
lar maintenance and checks. Damaged
blades must be replaced as a pair. Pro-
fessional repair is required if damage
occurs due to impact.
• The machine should be inspected and
maintained regularly by a responsible re-
pair service only.
• Wear suitable working clothes, i.e. pro-
tective glasses, protective means for
ears, non-slippery shoes and working
gloves. Do not wear broad clothes which
could be caught by the moving parts.
• After you finish using the clippers and
before cleaning them, it is necessary to
ensure that the machine cannot be acci-
dentally turned on, such as by unlocking
the switch.
• Check the cutting unit regularly for dam-
GB | Operating Instruction
• Never hold the clippers by the blades,
• Never touch moving blades in an at-
• Keep the machine away from children
• When working with the shears, always
• Do not use shears with a damaged or
• Ensure that all protective devices and
• Always use the protective part designed
• Before starting the work, make yourself
• Only use the spare sparts and accesso-
• Note that the user shall be responsible
• Prior to using the machine, inspect it
• Never use the machine with damaged
• Eye protection, long pants, and sturdy
• The machine should not be used in case
• Always switch off the machine
GB-6
age
you may run the risk of injury even when
the clippers are not moving!
tempt to remove debris or if the blades
are blocked. Always switch off the de-
vice.
and store it in a safe place.
take a stabile standing position, par-
ticularly when you are using steps or a
ladder.
excessively worn-out cutting part
handles are installed on the machine.
Never try to put an incomplete machine
in operation.
for the blade when transporting and
storing the shears.
familiar with the surroundings and pos-
sible dangers which you may not hear
because of the noise.
ries recommended by the manufacturer.
himself for accidents and hazards that
result to other people or their property.
visually for damaged, missing, or incor-
rectly attached protective devices or
coverings.
coverings or protective devices or with-
out the covering or protective devices.
footwear must be worn the entire time
the machine is used.
of poor weather conditions, especially in
case of lightning.
- if the machine is left unattended.
- before inspecting or working on the