Training The "Place" Command Using The Static Correction Mode - Petsafe Stay! Mat The Wireless Crate Guide D'emploi Et De Dressage

Phase
continued
2

Training the "Place" Command Using The Static Correction Mode

The Static Correction Mode should be used only if your dog does not respond to the Beep Only Mode.
Goal:
To train your dog to "Place" or "Stay" on the Stay! Mat
Correction Mode for training.
Setup:
• Put a separate non-metallic collar on your dog's neck ABOVE the Receiver Collar and attach a leash to it.
Note: Be sure the extra collar does not put pressure on the Receiver Collar's Contact Points.
• Have tiny pieces of your dog's favorite treats or a favorite toy available for training.
Steps:
1. Refer to page 11 for directions on "Finding the Static Correction Level Best Suited for Your Dog".
2. Once you have completed the steps for setting the Static Correction Level, instruct your dog to "Place" on the Stay!
™
Mat . While your dog is on the Stay! Mat
Mode.
3. At this point, each time your dog steps off the mat and the Receiver Collar begins to beep, he will also receive a mild
static correction. The beeping and the Static Correction will cease when your dog steps back onto the mat.
4. It is important at the beginning that you minimize the duration of the Static Correction. So, for the fi rst few times
your dog receives a Static Correction, gently guide him back to the Stay! Mat
of correction. This is a new experience for you and your dog, so remember to be patient during the training period.
5. At the end of the training session, remember to turn off the mat while your dog is still on it, give your dog the
"Release" command, remove the Receiver Collar, and praise and play with your dog for a good day's work.
10
™
, change the Stay! Mat
1-800-732-2677 (US) / 1-800-457-3911 (Canada
™
for a prolonged amount of time using the Static
™
switch to the Beep and Static Correction
™
with the leash within a few seconds
)