Adjustment - Gardeo GCBE18VCR-LI20L Traduction Des Instructions D'origine

ASSEMBLY
This manual gives instructions on the correct
assembly and safe use of your machine. It is
important that you read these instructions carefully.
Do not insert the battery before
product is completely assembled.
Ensure product is assembled in
the following order:
Fitting the trimmer head with telescopic tube
assembly (Fig.4-5)
Insert the telescopic tube assembly into the trimmer
head illustrated in Fig.4, making sure the arrow on
the trimmer head match with the arrow on the
telescopic tube assembly. Then tighten the
adjusting collar to fix the trimmer head with
telescopic tube assembly (Fig.5)
Mounting the Cutting Guard (Fig.6 -7)
Place the cutting guard on the trimmer head.
Fit the guard onto trimmer head and push till secure
fitting.
For safety, the guard can not be
disassemblied after fit to the
Mounting Plant hoop guard (Fig.8)
The plant hoop guard protects bushes, trees and
plants from being cut by accident.
Fit the plant hoop guard as Fig.8
Mounting the Wheels (Fig.9)
1. Fit the wheels onto the shaft.
2. Fit the bolt and the wing nut.
Note:
The position of the wheels can be adjusted by
loosening the wing nut and moving to the desired
position.
3. The wheels can be moved up and down the
shaft depending on the height of cut required.

ADJUSTMENT

Using Adjustable Handle (Fig.10)
The adjustable handle can be set in various
positions:
1. To change the position undo the handle wing nut
and move the adjustable handle.
2. Tighten the handle wing nut securely to fix the
adjustable handle in the adjusted position.
Adjusting Product Length (Fig.11-12)
Loosen the adjustment collar.
Pull the shaft out to increase the height, or push the
shaft in to decrease the height. Re-tighten
adjustment collar.
Adjusting cutting head angle:
The lawn trimmer is equipped with a four position
adjustable working angle. This enables
you to easily trim hard-to-reach areas in your
garden.
trimmer head.
To set the ideal working position, please follow the
instructions below.
The cutting head should be
inclined slightly forward while
Working angle (Fig.13)
• Free trimming
Working angle 1 & 2 Fig13
During free trimming, you should swing the trimmer
in a semi-circular motion in front of your body.
• Trimming under bushes / on slopes
Working angle 3 & 4 Fig13
• Edge function (vertical cut)
Working angle 4 Fig13
The edge function enables precise and convenient
trimming along the edge of the lawn.
1. Turn cutting head 90° (fig 14)
2. Set handle angle 4 (fig 14)
CUTTING AND EDGING
Remove stones, loose pieces of
wood and other objects from the
The blade continues to rotate for
a few seconds after the trimmer is
switched off. Allow the motor/
blade to stop rotating before
switching "on" again.
In order to take full advantage of
the battery capacity, you should
not switch the trimmer on and off
Switching On and Off fig 15
Press switch and hold depressed. Release switch
for switching off.
Fig.15
Cutting Grass
Move the trimmer left and right, keeping it well away
from the body.
Cut taller grass in stages.
Remove the wheels when cutting long grass
trimming.
cutting area.
unnecessarily.
33