Maintenance; Changing The Needle(S) - Husqvarna Viking ER10 Guide De L'utilisateur

Maintenance

Changing the needle(s)

Use #S1037 needles for the needle felting
machine. Do not use any other type of
needles.
Note: #S1037 needle is a very special needle and
is exclusive for the needle felting machine. Purchase
these needles at the same authorized dealer where you
purchased your machine.
When you change needle(s), unplug the
power cord from the wall outlet.
1. Turn the handwheel until the needle bar
is at the highest position.
2. Remove the presser height adjusting
screw and carefully remove the clear
fabric cover with needle guard, from the
machine.
3. Loosen the front needle clamp holder
fi xing screw by turning the 1.5mm Allen
wrench counter-clockwise.
4. Hold the needle clamp, lower it slowly
and remove it from the needle bar.
5. To remove the individual outer needles,
loosen the needle fi xing screw on the
needle clamp by turning the 1.5mm Allen
wrench counter-clockwise and remove
the needle(s). Insert the new needle(s)
until the top of the needle touches the
top of the needle hole. Tighten the
needle fi xing screw with 1.5mm hexagon
wrench by turning the Allen wrench
clockwise.
Note: #S1037 needles do not have a front or back,
therefore, you can insert the needle in any direction.
9