EINHELL GC-PT 2538/1 I AS Mode D'emploi D'origine page 23

Anleitung_GC_PT_2538_1_I_AS_SPK7__ 14.05.2019 13:33 Seite 23
11. Troubleshooting
Fault
The machine does not start.
The machine starts but does not
develop its full output.
The engine does not run smoothly
Engine smokes excessively
Possible cause
Correct starting procedure not
followed.
Sooted or damp spark plug
Incorrect carburetor setting
Incorrect choke lever setting
Soiled air filter
Incorrect carburetor setting
Incorrect electrode gap on the
spark plug
Incorrect carburetor setting
Incorrect fuel mix
Incorrect carburetor setting
Troubleshooting
Follow the instructions for starting.
Clean the spark plug or replace it
with a new one.
Contact an authorized customer
service outlet or send the machine
to ISC-GmbH.
Set choke lever to " "
Clean the air filter
Contact an authorized customer
service outlet or send the machine
to ISC-GmbH.
Clean the spark plug and adjust
the electrode gap or fit a new spark
plug.
Contact an authorized customer
service outlet or send the machine
to ISC-GmbH.
Use the correct fuel mix (see fuel
mixing table)
Contact an authorized customer
service outlet or send the machine
to ISC-GmbH.
GB
23