Air Circulation - Qlima P 432 Manuel D'utilisation

In the 'AUTO' position the fan will rapidly decelerate or accelerate depending on the
desired area temperature that has been set, and the actual area temperature.
G
4
5
4
84
COOLING
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Lowest setting.
Medium setting.
Maximum setting.
Automatic speed
• The temperature can be set by pressing the
between 16°C en 30°C. The display will show the set temperature.
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperature remains above the "set temp".
DEHUMIDIFYING
When the unit is primarily used as a dehumidifier, then please follow these
instructions: Do not connect the air exhaust hose and let the warm air go back
into the room. Connect a drainage hose onto the permanent drain connector
on the back of the unit. You must connect a drain tube to the water outlet.
See chapter I.
DEHUMIDIFCATION OPERATION
Press the button on the remote or the MODE button on the control panel
to select the dehumidifier mode. The fan will operate on low speed.
The dehumidifier indicator light will illuminate and stay solid while the
unit is dehumidifying. When the humidity in the room is 50% or lower, the
compressor will not run, the unit will not dehumidify, and the dehumidifier
light will blink.

AIR CIRCULATION

In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
• The fan speed can be adjusted by pressing the -button
Lowest setting.
Medium setting.
Maximum setting.
Automatic speed
When the unit is switched off the most recent setting will be stored in
memory.
The timer function allows you to switch the unit on or off at a certain time.
-button
and buttons, anywhere