Metabo DS 18DDX Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 13)
The LED light will automatically turn off 10 seconds
after the switch is released.
The LED light also functions as a warning signal that
lights up during use.
For details, see "12. LED light warning signals".
LED light
CAUTION
● Do not expose directly your eye to the LED light
by looking into the LED light.
If your eye is continuously exposed to the LED
light, your eye will be hurt.
11. Using the hook (sold separately)
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When carrying the power tool with hooked to
your waist belt, do not fi t any bit to the tip of
power tool. If the sharp bit such as drill is fi tted
to the power tool when carrying it with hooked to
your waist belt, you will be injured.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
Switch
trigger
Fig. 13
(1) Placing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 14)
Nut
(2) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 15)
English
Groove
Screw
Hook
Fig. 14
Screw
Hook
Fig. 15
15

Publicité

Table des Matières
loading

Table des Matières