SOLAC CT8696 Mode D'emploi page 14

DESCRIPTION
1. Pad
2. Cover
3. Power cord
4. Power cord connector
5. Pad connector
6. Control
a. Temperature control sliding switch
b. Temperature display screen
INSTRUCTIONS FOR USE
BEFORE USE:
Make sure that all products' packaging has
•
been removed.
USE:
Spread the pad out fully, making sure it's not
•
folded or creased.
Extend the cable completely before plugging
•
it in.
Ensure that the electronic connector is proper-
•
ly attached to the appliance.
Connect the appliance to the mains.
•
Turn the appliance on, by using the on/off
•
switch.
The pilot light comes on.
•
The 3-heat controller comes with an easily ad-
•
justable temperature slide switch and a heat
setting display.
The 3-Heat controller offers the following set-
•
tings:
0 = Off
1 = Low Heat
2 = Medium Heat
3 = High Heat
As a security measure, the appliance is pro-
•
grammed to turn off automatically after 90 min.
of continuous use. If the appliance is stopped
in this way, set the power switch to "0" position
and then back to the desired temperature
ONCE YOU HAVE FINISHED USING THE AP-
PLIANCE:
Turn the appliance off, using the on/off switch.
•
Unplug the appliance from the mains.
•
Clean the appliance.
•
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
The pad may be washed by hand or by ma-
•
chine at a temperature of up to 40ºC. Remove
the control before washing (Fig. 1). The control
must never be submerged in water.
Dry the product immediately after any clean-
•
ing task making sure that the appliance inlet is
perfectly dry.
The pad has a removable cover that can be
•
washed by hand or machine at a temperature
that does not exceed 40 ºC.
Do not use the pad if the removable cover is
•
not completely dry.
Never submerge the connector in water or any
•
other liquid or place it under running water.
WHEN NOT IN USE, STORE AS
FOLLOWS:
Let the appliance cool down before putting it
•
away.
When the appliance is not in use, keep in a dry
•
place and avoid placing heavy objects on top
as they could damage the cables.
Avoid creases forming. Check the appliance
•
and power cord frequently to make sure they
are in perfect condition.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
•
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
EN