Sub-Zero ICB424 Guide D'utilisation Et D'entretien page 20

T R O U B L E S H O OT I N G
T R O U B L E
If your Wine Storage unit is not operating
properly, refer to the following Trouble-
shooting guide before calling your Sub-Zero
authorized service center or dealer. This guide
will save you time and trouble and may help
you avoid the expense of a service call.
The Wine Storage unit is not operating
The Wine Storage unit is warmer than
usual
The Wine Storage unit runs for long periods
of time
20
S H O O T I N G
Is there electrical power to the unit?
Is your home circuit breaker or fuse on?
Is the unit on? Depress the
Is the condenser area clean?
Is the control set properly?
Is the condenser area clean?
Have the door or drawers (Model ICB427R)
been open for a long time?
Is the condenser area clean?
On hot days and in warm room tempera-
tures, the compressor runs longer.
Have the door or drawers (Model ICB427R)
been open for a long time?
Have you recently added a large amount
of wine?
G U I D E
Condensation forms inside the unit
Condensation forms outside the unit
key pad.
You need product information
You need service
This is normal during periods of higher
humidity (summer) and with frequent door
openings.
Are the door and drawers (Model ICB427R)
closing and sealing properly?
During periods of high humidity, some
condensation may appear on outside
surfaces. The condensation will disappear
when the humidity drops. Be sure that the
door and drawers (Model ICB427R) are
closing and sealing properly. If condensa-
tion persists, contact your Sub-Zero author-
ized service center.
Visit our website, subzero.com,
for planning, installation and product
information.
If service is necessary, maintain the quality
built into your Sub-Zero unit by calling a
Sub-Zero authorized service center.
To obtain the name and number of a
Sub-Zero authorized service center, check
the Contact & Support section of our
website, subzero.com.
When calling for service, you will need the
model and serial number of your unit. For
Models ICB424 and ICB424FS, the model
and serial number plate is located on the
underside of the top wall. For Models
ICB427 and ICB427R, it is attached to the
underside of the control panel. For Model
ICB430, the plate is located inside the door
near the top hinge on the main frame
extrusion.