Sub-Zero ICB424 Guide D'utilisation Et D'entretien page 13

S U B - Z E R O W I N E S TO R AG E
B OT T L E S TO R AG E
M O D E L I C B 4 2 7 R
D R A W E R R E M O V A L
Model ICB427R: Disconnect the control cable
before removing the top drawer. Refer to the
illustration below.
To remove a drawer from the Model ICB427R,
pull the drawer open until it stops. Lift up
evenly on both sides of the drawer front and
pull out, as shown in the illustration below.
IMPORTANT NOTE: Be sure to unload the
contents before removing the drawer.
To replace a drawer, raise the front of the
drawer up and place onto the drawer slide
tracks. Be sure to engage the front holes of the
drawer slide with the small pegs at the end of
each rail.
Before removing the top drawer of the
Model ICB427R, you MUST disconnect
the control cable.
Control cable –
Model ICB427R
U S E & C A R E
D R A W E R S –
Drawer removal – Model ICB427R
D R A W E R D I V I D E R
Model ICB427R: Each drawer of the Model
ICB427R has a permanent divider.
13