Ariston E8.5064 Cascade Manager Mode D'emploi page 53

confi guring the settings
CONFIGURING THE SETTINGS FOR HEATING CIRCUIT 1 - 2
CAUTION: If you use a BM8 remote control with circuit, the following should be done on the
same remote control. Open the door, turn the control and select the "EXPERT" ed il livello "HTG
CIRCUIT 1", poi:
• press the programming button
• turn the control to select the "MAX T- -FLOW" parameter;
• press the programming button
set the "CODE- -NO" at "0000" (by pressing the button 4 times);
• press the programming button
PARAMETER
MAX T- -FLOW
MAX T- -FLOW
URN THE CONTROL AND SELECT THE "MIN T- -FLOW" PARAMETER
MIN T- -FLOW
MIN T- -FLOW
;
(red LED on);
DISPLAY SCREEN
7 0
PRESS THE PROGRAMMING BUTTON "
PRESS THE PROGRAMMING BUTTON "
4 0
PRESS THE PROGRAMMING BUTTON "
URN THE CONTROL AND SELECT THE "RETURN" PARAMETER
PRESS THE PROGRAMMING BUTTON "
FIGURE DESCRIPTION
Turn the control and set the max supply
70
temperature for circuit 1 in °C (e.g. "70")
"
" (
RED LED ON)
Turn the control and set the minimum supply
40
temperature for circuit 1 in °C (e.g. "40")
"
" (
TO EXIT)
GB
53