Ariston E8.5064 Cascade Manager Mode D'emploi page 49

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 58
confi guring the settings
CONFIGURING THE TECHNICIAN'S PARAMETERS
Open the door, turn the control
and select the "EXPERT" fi eld and the "INSTALLATION" fi eld, then:
• press the programming button
• set the "CODE- -NO" at "0000" (by pressing the button 4 times);
• turn the control to select the "BUS- -ID HS" parameter;
• press the programming button
PARAMETER
BUS- -ID 1
BUS- -ID 1
TURN THE CONTROL AND SELECT THE "BUS- -ID HS 2" PARAMETER
BUS- -ID 2
BUS- -ID 2
Ruotare LA MANOPOLA SELEZIONARE IL PARAMETRO "TIMER MASTER"
TIMER MASTER
TIMER MASTER
;
(red LED on);
DISPLAY SCREEN
0 1
PRESS THE PROGRAMMING BUTTON "
PRESS THE PROGRAMMING BUTTON "
0 2
PRESS THE PROGRAMMING BUTTON "
PRESS THE PROGRAMMING BUTTON "
0 1
FIGURE
DESCRIPTION
Turn the control and set at "01" for a combi-
01
ned heating circuit (or 00 for a direct circuit).
"
" (
RED LED ON)
Turn the control and set at 02 for a combined
heating circuit (if you see four dashes on
02
the screen, check the VFAS delivery probe of
circuit 2 is connected)
"
" (
RED LED ON)
Turn the control and set at 01. All the periphe-
01
rals are now set at the same date and time as
the E8 control unit.
GB
49

Publicité

Table des Matières
loading

Table des Matières