Publicité
Les langues disponibles
Les langues disponibles
rules For saFe oPeraTIoN
The following safety precautions are suggested. This
broadcast spreader is designed, engineered and tested to
offer reasonably safe and effective service, provided it is
operated in strict accordance with these instructions. Failure
to do so may result in personal injury. Always observe the
rules of safe operation.
1. Do not allow anyone to operate the spreader without
proper instructions.
2. Do not permit children to operate the spreader.
3. Wear eye and hand protection when handling and when
applying lawn or garden chemicals.
4. Read the label instructions and cautions for handling
and applying the chemicals purchased for spreading.
5. Keep all nuts, bolts and screws tight to be sure equipment
is in safe working condition.
6. Follow maintenance and lubrication instructions as
outlined in this manual.
asseMBlY INsTruCTIoNs
1. Raise Handle Tubes to the upright operating position
and tighten the (4) Wing Nuts.
2. Attach the Flow Control Assembly to the inside of the
Handle Tube as shown.
oPeraTING INsTruCTIoNs
ADJUSTING THE FLOW RATE SETTING
1. Loosen the wing nut that fastens the control to the
handle.
2. Slide the Adjustable stop to the desired setting and
retighten the wing nut.
ADJUSTABLE STOP
FLOW CONTROL LEVER
usING Your sPreaDer
1. Check the material package and the Spreader Settings
sheet included with your spreader for the proper spreader
setting and application rate.
2. Before filling spreader, push the control lever to the
"OFF" position.
3. Move spreader onto a flat surface - either a walk or a
driveway - and fill.
4. Slide the Adjustable Stop to the desired setting.
5. Start the spreader in motion and then move the control
lever forward to the "ON" position as you walk across
your lawn.
NoTe: Always place control lever in the "OFF" position
while filling spreader and when stopping or turning, to
prevent release of excess fertilizer.
aPPlICaTIoN TIPs
1. To avoid misses or striping, overlap the previous wheel
tracks by approximately 3 inches.
2. For easiest application, spread across the shortest
edges of lawn first, making two "header" strips for a
turning area, and then spreading between the header
strips. See figure 1.
3. If lawn is odd shaped, spread a border around the edges
and then spread between the border. See figure 2.
IMPorTaNT: Be careful when using spreader around
ornamental plants because weed controls can damage
these plants.
FIGure 1
MaINTeNaNCe/sToraGe
CHeCK For loose FasTeNers
1. Make a thorough visual check of the Spreader for any
bolts and nuts which may have loosened. Retighten any
loose bolts and nuts.
CleaNING
1. Always empty spreader after each use, storing leftover
material in it's original bag.
2. Wash the spreader and dry thoroughly after each
use.
sToraGe
1. Empty and clean the hopper as instructed in maintenance
section.
2. Store in a clean, dry area.
2
FIGure 2
Publicité
