Local Configuration; Firmware Updates; Power Setting - newmotion Home Advanced Edition 7 Mode D'emploi

5. LOCAL CONFIGURATION

The Home Advanced Edition can be configured locally
using the Home Charging by NewMotion app.
Three items are required for local configuration:
1. Charge point which is installed and on power
2. QR Code for WiFi Direct connection
3. Home Charging by NewMotion app
Make sure that the charge point is powered on for at
least 5 minutes.
TIP: Make sure to have the Home Charging by
NewMotion app already installed on your smartphone,
before installing the charge point.
- Open the Home Charging by NewMotion app
on your phone
- Follow the steps as described in the Home Charging
by NewMotion app
- Use the QR Code for WiFi Direct connection, which is
included in the charge point package, when the Installer
App requests to scan a QR Code
5.1 CABLE LOCK
Enable the cable lock feature to permanently lock the
charge cable.

5.2 POWER SETTING

Select the maximum allowed current for the installed
circuit. Taking into account the MCB, RCD, grid
connection and local regulations.
5.3 DYNAMIC POWER MANAGEMENT
SETTING
Enable Dynamic Power Management if upstream
Dynamic Power Management module is installed.
When Dynamic Power Management is enabled, fill in
the maximum current of the grid connection as the
installation max current.
INSTALLATIEHANDLEIDING – P26
INSTALLATION MANUAL – P26 | P26

5.4 FIRMWARE UPDATES

Use the Home Charging by NewMotion app to download
and install the latest firmware release for the Home
Advanced Edition charge point.
5.5 START CHARGING SETTING
Set whether the charge session will be started
automatically after connecting the cable and car (default)
or using an RFID charge card.
VERSION 0129NM02INT01
07ANM20INT01