Husqvarna 531RS Manuel D'utilisation page 12

10. Connect the stop switch wires (H) with the
connectors from the engine.
H
11. Install the dust cover (J).
12. Install the air filter cover.
To install blades and trimmer heads
WARNING:
guard for the blades. See
page 25 . A defective guard can cause
injury.
WARNING:
with a grass blade, first install the correct
handlebar, blade guard and harness .
WARNING:
blades correctly, it can cause injury.
1. Make sure that the lifted section on the drive disc/
support flange engages correctly in the center hole
of the blades.
12
J
Only use the approved
Accessories on
If you operate the product
If you do not install the the
2. Install the blades.
To attach and remove the guard extension
The guard extension is used on the cutting attachment
guard. Attach the guard extension when you use a
trimmer head or plastic blades. Remove the extension
guard when you use a grass blade.
• Put the guide on the guard extension into the slot on
the cutting attachment guard. Lock the 4 locking
hooks into position.
• Release the locking hooks with a screwdriver to
remove the guard extension.
To attach a blade guard, grass blade and
grass cutter
CAUTION:
extension is removed.
Note:
Use the recommended blade guard. Refer to
Accessories on page 25 .
Make sure that the guard
1274 - 005 - 28.05.2021