Husqvarna 531RS Manuel D'utilisation page 15

Gasoline, liter
15
20
To make the fuel mixture
Note:
Always use a clean fuel container when you mix
the fuel.
Note:
Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
WARNING:
objects near fuel. Before you add fuel, stop
the engine and let it cool for minutes.
WARNING:
the fuel tank cap slowly to release unwanted
pressure.
WARNING:
the fuel tank cap carefully. Move the
machine away from the refuelling area and
the power before you start the engine.
• Always use a fuel container with an anti-spill valve.
• Make sure that the area near the fuel tank cap is
clean. Contamination in the tank can cause
operating problems.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
To examine before start
1. Examine the product for missing, damaged, loose or
worn parts.
2. Examine the nuts, screws and bolts.
3. Examine the blades.
4. Examine the locknut. Make sure that the locknut has
a minimum locking force of 1.5 Nm (1,1 ft lb). Torque
the locknut to 35-50 Nm (26-36 ft lb).
5. Examine the air filter.
1274 - 005 - 28.05.2021
Oil, liter
0,3
0,4
Do not smoke or put hot
When you add fuel, open
After you add fuel, tighten
6. Examine the throttle trigger lockout and the throttle
control.
7. Examine the stop switch.
8. Examine the product for fuel leaks.
To start a cold engine
WARNING:
product, install the complete clutch cover
and shaft. A loose clutch can cause injury.
Use gloves.
WARNING:
from the refuelling area and the fuel source.
Put it on a flat surface. Make sure that no
objects touch the cutting attachment.
WARNING:
unauthorised persons are in the work area.
Or it can cause a risk of dangerous injury.
The safety distance is 15 m.
1. Put the stop switch to the start position.
2. Push the air purge bulb until fuel starts to fill the
bulb.
3. Move the choke control to the choke position.
Before you start the
Move the product away
Make sure that no
15