Usb Interface - ARRI L Série Guide Rapide

USB INTERFACE

The luminaire is equipped with an USB interface (Mini USB
connector 11). The interface can be used for uploading
new firmware, setting parameters or for service purpose. A
service tool for Windows, MACOS and Linux allows the
control and programming of the luminaire using this
interface.
The latest firmware and the ARRI Lighting Service
Manager software tool are located in the download area of
our website www.arri.com for free download.
POWER-ON AND OPERATION
By switching the power switch on (or by applying the mains
power on luminaires without a power switch), the luminaire
starts lighting after a short startup time with the same
setting which had been active at its last switch off.
The luminaire can now be controlled over the DMX
interface, over the USB interface or by the integrated fixture
menu (14).
Modes of Operation
WHITE LIGHT
The luminaire generates white light with an optimized color
rendition. The color temperature and the green / magenta
correction can be continuously adjusted.
COLORED LIGHT
The luminaire generates white or colored (only "C"
versions) light. The color tone (hue) and the color
saturation can be adjusted continuously. At very low color
saturation, the luminaire generates white light without an
optimized color rendition.
The operating modes can be changed by shortly pressing
the FUNCT button.
Indication Panel and Integrated Fixture Menu
The luminaire is equipped with an integrated fixture menu.
It supports the following functions:
POWER/STATUS Indicator
 continuous green:
powered, no malfunction
 blinking red:
over temperature warning

continuous red: malfunction or over temperature
DATA Indicator
 lights blue when a valid DMX signal is present
CCT Controller
 to adjust the correlated color temperature (CCT) in the
white light mode
 to adjust the color hue in the colored light mode
(only "C" versions)
FUNCT Button
 to change the operating mode between white and
colored light (only "C" versions)
 to exit a sub-menu (escape)
ENTER Button
 to confirm an input
 to jump into a sub-menu
+ Button
 to show the menu
 to move upwards in a menu
 to increase a value
- Button
 to show the menu
 to move downwards in a menu
 to decrease a value
1 and 2 button
 To record (press and hold) and recall (short press) of
user–defined presets.
Note: Only the settings of the CCT/HUE and GN/SAT
controllers will be stored.
Intended use
This product is intended to illuminate persons and objects
in a dry environment.
Always follow the safety information.
Any usage other than described above is not permitted and
can damage the product and lead to associated risks such
as short-circuit, fire, electric shock, etc. You are not allowed
to modify the product.
This product fulfils European and national requirements.
ARRI Service
In case of technical problems please visit us at
www.arri.com
Arnold & Richter Cine Technik GmbH & Co. KG
Service Lighting
Pulvermuehle
D-83071 Stephanskirchen
Germany
Design and specifications are subject to change without
notice.