Transport, Packaging And Storage - WIKA TR31-3 Mode D'emploi

4. Transport, packaging and storage

4. Transport, packaging and storage
4.1 Transport
EN
Check the instrument for any damage that may have been caused by
transport. Obvious damage must be reported immediately and damaged
instruments must not be used.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property
can occur.
▶
▶
If the instrument is transported from a cold into a warm environment, the
formation of condensation may result in instrument malfunction. Before
putting it back into operation, wait for the instrument temperature and the
room temperature to equalise.
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport
(e.g. change in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature:
■
- M12 x 1, 4-pin circular connector: -40 ... +85 °C [-40 ... +185 °F]
- Directly connected cable:
Humidity: 5 ... 95 % r. h.
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
■
12
When unloading packed goods upon delivery as well as
during internal transport, proceed carefully and observe
the symbols on the packaging.
With internal transport, observe the instructions in chapter
4.2 "Packaging and storage".
WIKA operating instructions models TR31-3, TR31-K
-20 ... +80 °C [-4 ... +176 °F]