Troubleshooting Table - tomado TWM8001W Mode D'emploi

WARNING!
• Never remove the pump filter cap during a washing cycle. Always wait until the appliance has finished the cycle,
and is empty.
• When the appliance is in use and depending on the selected programme, there can be hot water in the pump.
• When replacing the pump filter cap, ensure it is securely snapped in place.
OPENING THE DOOR MANUALLY IN CASE OF A POWER OUTAGE - IN CASE OF A PROGRAMME PAUSE
In case of a power outage during a washing cycle, the programme will resume after the power is restored in most cases.
If not, you can manually open the door and remove the laundry.
WARNING!
• If there is still water in the appliance after a power outage, make sure not to open the door before you manually drain
the water from the appliance via the pump filter (see the paragraph CLEANING THE DRAIN PUMP FILTER).
1. When the programme is paused or interrupted, open the pump filter cap.
2. The door of the appliance can only be opened by simultaneously pulling the special lever - next to the filter -
and the door handle.
3. Open the door manually by pulling the handle towards you.
• TROUBLE SHOOTING
The appliance will automatically control the operation of particular functions during the washing cycle. If any irregularity
occurs, this will be identified by reporting (E:XX) on the display. The appliance will report the error until it is switched off.
Disturbances from the environment (e.g. the power grid) may result in various error reports. In such case:
• Switch off the appliance and wait for a few seconds.
• Switch the appliance on and repeat the washing programme.
• Most errors during operation can be solved by the user.
• If the error persists, call the customer care service.
• Repairs may only be carried out by an adequately trained person.
• Repair or any warranty claim resulting from incorrect connection or use of the appliance shall not be covered by the
warranty. In such cases, the costs of repair shall be charged to the user.
• The warranty does not cover the errors of failures resulting from disturbances from the environment (lighting strike,
power grid failures, natural disasters etc. ).
TROUBLE SHOOTING TABLE
Description
The appliance does not start
The door can't be opened
The appliance does not fill
with water.
Water leakage
Detergent residues in the
dispenser tray
Indicator or display does not work
Possible cause
The door is not closed properly.
Clothes are stuck.
The safety protection is activated.
The water tap is not open.
A shut-off system in the aquastop is
activated. The internal tube or the
water supply hose is damaged.
The connections are not tight enough.
The detergent is damp and/or clotted.
PC board is not connected or harness
has connection problems.
EN - 49
What to do?
Close the door properly and restart.
Check the laundry.
Disconnect the power and restart.
Open the water tap completely.
When the aquastop is acitvated, it cuts the
water supply off. The control glass on the
aquastop will be red. Replace the water
supply hose.
Check and fasten the water supply hose.
Check and clean the water discharge hose.
Clean and wipe the dispenser tray dry.
Switch off the power and check if the mains
plug is connected properly.