tomado TWM8001W Mode D'emploi page 43

Hygiene Pro
Hygiene Pro is not an additional function you can choose. It is automatically added to some programmes and the
indicator will light up if one of the programmes is selected which include Hygiene Pro.
Hygiene Pro cleans your drum and the glass of the inner door with cold water at the end of the washing cycle.
This self-clean function keeps your appliance and laundry clean and will be automatically activated during the
washing cycle. Check the chapter SELECTING ADDITIONAL FUNCTIONS to see which programmes include the
Hygiene Pro function.
Adding laundry
It is possible to add or remove laundry during a washing cycle. After a certain period of time, the appliance door
Was toevoegen
can be opened if the water level and temperature are below a predefined threshold.
3 sec.
If the conditions below are met, then the electronic door lock is released and the appliance door can be opened:
• water temperature in the drum has to be suitable;
• water level in the drum has to be below a certain value.
i
CAUTION!
When the drum is still rolling and there is a large amount of water with high temperature in the drum, the state is unsafe and
the door cannot be opened forcefully.
• Don't use the ADDING LAUNDRY function when the water level is over the edge of the inner drum or when the water
temperature is high.
In order to add or remove laundry from the drum during a washing cycle, proceed as follows:
1. Press the START PAUSE button for 3 seconds.
2. Wait until the drums stops rotating.
3. The door will unlock.
4. Open the door and add or remove the laundry.
5. Close the door and press the START PAUSE button. The washing cycle will resume.
i
CAUTION!
• If a considerable amount of laundry is added during the washing cycle, the laundry could be washed less effectively, since the
appliance initially sensed a lower weight of the laundry load and added a smaller amount of water. Insufficient amount of
water relative to the amount of laundry could also cause damage to the laundry (rubbing of dry laundry), and the washing
time can be longer.
• The washing time will resume from the point at which the washing programme was interrupted.
Temp °C Muting the buzzer
The sound of the buzzer can be muted. Proceed as follows to mute the buzzer:
3 sec.
1. Choose any programme.
2. Press the TEMPERATURE button for 3 seconds. The buzzer is mute.
Activating the buzzer
1. Choose any programme.
2. Press the TEMPERATURE button for 3 seconds. The buzzer is activated again.
i
CAUTION!
• After muting the buzzer function, be aware that there are no sounds activated anymore.
Display
The display shows the settings, estimated time remaining, spinning rate, temperature, start delay, options and status
messages for your appliance. The display will remain on during the cycle.
Wash time
Spinning rate
Start delay
Temperature
EN - 43
End
Error