Cleaning The Drain Pump Filter - tomado TWM8001W Mode D'emploi

Cleaning the inlet filter at the back of the appliance
1. Close the water tap.
2. Unscrew the water supply hose from the back of the appliance.
3. Pull out the filter with a long nose plier and clean the filter using a brush
under running water.
4. Reinstall the filter to the water inlet and reconnect the water supply hose.
5. Open the water tap.
CLEANING THE DISPENSER TRAY
1. Open the dispenser tray and press down the release [
the softener compartment and pull the dispenser tray out of the recess.
2. Lift the cover of the softener compartment of the dispenser tray. Wash
both items, the cover and the complete dispenser tray under running water.
Make sure not to forget to clean the drain hole of the softener compartment
and the openings at the bottom of the dispenser tray.
3. Clean the inside of the recess with a brush.
4. Reinstall the cover of the softener compartment and push the dispenser tray
back in the recess.
i
• Do not use abrasive or caustic agents to clean plastic parts.
• Cleaning the dispenser tray every 3 months ensures normal operation
of the appliance.

CLEANING THE DRAIN PUMP FILTER

The pump filter can filter the yarns and small foreign matters from the washing. Especially after washing fleecy, woolly or
very old laundry.
WARNING!
• Unplug the appliance to avoid electrical shock before cleaning.
• Be careful of hot water!
• Allow detergent solution to cool down.
• During cleaning, some water may be spilled. It is recommended to place an absorbent cloth on the floor.
Open the pump filter cap.
Open the pump filter by turning
it counter clockwise. Clean the
pump filter under running water.
] on the cover of
Turn 90°, pull out the emergy
discharge hose and remove
the cap.
Remove any objects and
impurities from the filter
housing.
EN - 48
When there's no more water
coming out, put the emergy
discharge hose back.
Place the pump filter back and
turn it clockwise to lock it.
Close the pump filter cap.