Other Functions - tomado TWM8001W Mode D'emploi

TPM Spinning rate
When needed, the spinning rate can be adjusted by pressing the TPM button.
There are 7 settings: 0 - 400 - 600 - 800 - 1000 - 1200 - 1400 [ --- - 400 - 600 - 800 - 10- - 12- - 14- ].
Temp °C
Temperature
When needed, the washing temperature can be adjusted by pressing the temperature button.
3 sec.
There are 6 settings: Cold - 20°C - 30°C - 40°C - 60°C - 90°C [ -- -20°C-30°C-40°C-60°C-90°C ].
Startuitstel
Start delay
Use this function to start the washing cycle after a certain amount of time has elapsed. Proceed as follows:
1. Select a programme
2. Press the START DELAY button to choose the delaying time. Set the hours by repeatedly pressing or holding
the START DELAY button. It can be set from 0 up to 24 hours.
3. Press START /PAUSE button to start the delay.
i
NOTE!
• When using the START DELAY, preferably use a washing powder instead of a liquid detergent.
Canceling start delay
To cancel the START DELAY function, press the START DELAY button, before the washing programme is started,
until the display shows 0 H.
Functie

OTHER FUNCTIONS

Child lock
This function is a safety feature and prevents children from misusing the control panel.
To activate the child lock, proceed as follows:
• Press the START DELAY and FUNCTION button simultaneously for 3 seconds until the buzzer beeps.
The child lock indicator switches on, the display will alternately show [ CL ] and the remaining time,
when the appliance is running a washing programme.
Deactivating the child lock
• Press the START DELAY and FUNCTION button simultaneously for 3 seconds until the buzzer beeps.
The child lock indicator switches off.
i
CAUTION!
When the CHILD LOCK is activated, the display will alternately show [ CL ] and the remaining time, when the appliance is
running a washing programme.
Pressing any button will cause the CHILD LOCK indicator to flash for 3 seconds. When the programme ends, [ CL ] and [ END ]
will alternate on the display for 10 seconds, then the indicator will flash for 3 seconds.
The Child lock deactivates the function of all buttons except the on/off knob and the child lock button combination!
Only the simultaneous pressing of the two buttons START DELAY and FUNCTION can deactivate the child lock.
Please deactivate the child lock before selecting a new programme!
Pre-wash
Before the main washing cycle starts, the laundry will be extra washed to increase the washing performance.
Particularly suitable for heavily soiled laundry with stubborn superficial stains.
Note: Don't forget to also add detergent to compartment I.
Extra rinse
The laundry will undergo an extra rinse after selecting this function.
Extra wash
The washing time and intensity are increased for a better cleaning effect of heavily soiled laundry.
EN - 42