Water Installation - tomado TWM8001W Mode D'emploi

• Connection to water and power supply has to be executed by an
adequately trained technician or expert.
• Any repair and maintenance pertaining to safety or performance
should be done by trained experts.
• In case of a defect, only use approved spare parts by authorized
manufacturers.
• In case of incorrect appliance connection, incorrect use,
or servicing by an unauthorized person, Tomado will not be
responsible for any damage as such damage will not be covered
by warranty.

WATER INSTALLATION

• The appliance is equipped with a single inlet valve and can be
connected to the cold water supply only.
• To connect the appliance to the water supply, make sure to use
the supplied water supply hose and gaskets.
The water pressure has to be between 0.05 and 1.0 MPa
(0.5 - 10 bar).
• Always use the supplied new water supply hose to connect
the appliance to the water supply; do not reuse an old water
supply hose.
• The end of the water discharge hose should reach into a water
drain line.
• Check the connections of the water supply hose, the water tap and
the water discharge hose for possible problems due to changes of
water pressure. If the connections loosen or leak, close the water
tap and get it repaired. Do not use the appliance before the pipes
and hoses are installed properly by authorized persons.
At higher washing temperatures, the door glass will heat up.
Be careful to avoid burns. Keep children and animals far away from
the machine while it is operating.
Do not remove the drain pump filter while there is still water in
the appliance. Big quantities of water can leak out, and there is
a risk of scalding due to hot water.
EN - 31