Installation And Connection; Unpacking The Appliance - tomado TWM8001W Mode D'emploi

REQUIRED SPACE FOR INSTALLING
WARNING!
• Stability is important to prevent the product from sliding across the installation site!
Make sure to level the appliance and install it on a stable base in longitudinal and traverse direction
by rotating the adjustable feet.
• Make sure the appliance doesn't stand onto the power cord.
• Make sure to observe the minimum required clearances from the walls as indicated in the figure.
i
The room in which the appliance is placed must meet the following requirements:
1. Dry, level and stable solide base
2. Avoid direct sunlight
3. Sufficient ventilation
4. Room temperature is above 0°C
5. Keep far away from heat sources such as coal, gas or wood burning appliances.

UNPACKING THE APPLIANCE

WARNING!
• Move the appliance with at least two people and wear protective clothing, such as sturdy gloves.
• Packaging material (e.g. films, styrofoam) can be dangerous for children.
• There is a risk of suffocation! Keep all packaging away from children.
1. Remove the cardboard box and the styrofoam packing.
2. Lift the washing machine and remove the base packaging. Make sure the small triangle foam [A]
is removed with the bottom packaging together. If not, lay the appliance down on one side and
carefully remove it manually.
3. Remove the tape securing the power supply cord and water discharge hose.
4. Take the water supply hose out of the drum.
REMOVING THE TRANSPORT BOLTS
WARNING!
Before the first use of the appliance, the transport bolts must be removed from the back of the appliance. A blocked appliance
may be damaged when it is switched on for the first time. The warranty does not apply in cases of such damage!
Loosen the 4 transport bolts
with a spanner.

INSTALLATION AND CONNECTION

Remove the bolts including
the rubber parts and keep them
for future use
EN - 36
Close the holes using
the cover caps
W ≥ 20 mm
A