How To Assemble The Roof (Vex Option) - P.LEMMENS hrmural TAC 5 Manuel D'installation Et De Maintenance

2.3. How to assemble the roof (VEX option)

The roof (VEX) option is delivered unassembled for transportation reasons.
Please follow these instructions to assemble the different parts:
a) Remove the plastic film from the top part of the HRmural unit. Make a silicone seal (not supplied) between
the panels and between the aluminum profiles on the top part of the unit, as shown on the picture a)
b) Place the different elements of the roof on top of the HRmural unit, over the silicone seals. Make sure you
leave an adequate distance on each side of the unit so as to cover the whole unit properly.
Available distance on each side of the unit:
Unit type
HRmural 450
HRmural 450 ECO
HRmural 450 ECO HP
HRmural 600
HRmural 800
HRmural 1200
b)
c) The screws must be screwed into the aluminum profile and properly aligned. Use a pen to point the location of
the screw. Mount the plastic caps supplied over the screw heads as shown on the picture c).
d) Insert silicone inside the U-clip used to join the different roof parts and place the clip over the roof sections as
shown on pictures d1) and d2)
e) Make a silicone seal between the aluminum profile and the roof all around the unit, as shown in picture e)
d)
d2)
On the sides
75 mm
50 mm
50 mm
75 mm
75 mm
71 mm
29
On front and back
100 mm
50 mm
50 mm
100 mm
70 mm
102 mm
b)
d1)
e)