Sport-thieme TT Maxima Instructions De Montage Et Utilisation page 17

Enter the cam (36) between the
decorative cover (28) and (29) and the
shaft (37) Fig.6
(6) along with the washers (43).
Then enter the arms (39) and the arc
plate (41) on the cam (36) with cap
(40) and tighten with screws (6) and
(38) along the washers (43) and (14)
Figure 6.
Screw the tip of the cable (59) onto
the weight guide (12), Fig.7, then
take the other end of the cable (59)
and pass it through the top pulleys
(49) and the middle pulley (48) as
shown in Fig.7.
Then mount pulleys (49) onto the
upper support (15) Fig.7 using
screws (53), (56), (57), (50), (63)
and (22) along with the washer (5),
the spacer (58), the guide (54) and
the plates (48) and tighten using
nuts (16) shown in fig 7.
Attach the chain (60) onto the cable
using the carabiner and the pull bar
(61), Fig.7.
Next thread cable (64), with the
pulleys in the supports (A); (B); (C);
(D); and (E) using (57), (22), (62)
and (56) along with the washers (5),
and (14), the guide (54) and (55)
and tighten using nuts (16) and (9)
shown in fig 8.
Take the chain hook (60) and join
the end of cable (64), which you
have just threaded through, with the
cable tensioner (65), Fig.8. Attach
the end of the cable (64) to the
pulley bracket (42) along with the
screw (83) with washer (5) and
tighten the nut (16) fig 8.
Thread cables (68) and (69), with
the pulleys in the supports (G); (H);
(I); (J); (K); (L); (M) and (N) using
screws (57), (67), (62) and (56)
attach using screws
along with the washers (5),
(14), the guides (51), (54) and (55)
and tighten using nuts (16) and (9)
shown in fig 9.
Attach the end of the cable (68) to
the chassis (1) along with the chain
(60) onto the cable using the
carabiner.
Attach the chain (70) onto the cable
using the carabiner and the handle
(71), Fig.9.
Take the seat (75) and position it on
the leg support (26), Fig.10. Attach
using screws (74) and washers (14).
Insert the caps (77) in the leg tube.
Place the bottoms foams (80) of the
leg support (27).
Finally, fit the caps (78) onto the
ends of the foam covers (80), Fig.10
along with the screws (79).
Take the backrest (73) and position
it to the backrest support (72), as
shown in Fig.10.
Now use screws (74) and washers
(14) to secure the backrest, Fig.10.
Insert the shaft (76) in the backrest
support guide (72).
(77) into the axle (76). Fit the caps
(78) onto the ends of the foam
covers (80), Fig.10 along with the
screws (79).
Place the backrest to the main body
(25) and secure it with the knob (24)
Fit the left and right safety covers
(81) onto the top bracket (18),
Fig.10, hand tightening screws (38)
along with the washers (14) on the
top section, Fig.10.
Also fit covers on the the bottom
bracket (1) Fig.10, using screws (38)
with washers (14), on the bottom
section, Fig.10.
17
and
Insert the caps