Publicité
Les langues disponibles
Les langues disponibles
Place the weights (11) onto the
guide bars as shown in Fig.3.
Now take the weight selector post
(10), Fig.3 with the weights (12) and
insert it onto the last weight, fit the
selector ring (13) onto the central
boss on the weight selector post, as
shown in Fig.3.
Finally place the top cap for the
weights (7), Fig.3, fit screws (8)
along with the washers (14) and nuts
(9) and tighten securely.
Place the main body (25), onto the
frame (1), Fig.4. Fit screws (19)
along with the washers (20) and nuts
(21) and tighten securely.
Place the bracket (18) on the bars
(2) as shown in Fig.4.
Place the upper body (15), Fig.4,
onto the main body (25) and the
support (18), Fig.4. Insert the screws
(19) along with the washers (20) and
nuts (21) and tighten securely.
Now fit screws (6) along with the
washers (5) and nuts (16) and
tighten securely.
By other side place the screws (4)
along with the washers (5) and
tighten securely as shown in fig 4
Finally place the lateral plates (17) to
the body (15) and (1)
screws (22) washers (5) and nuts
(16).
Place the knobs (23) and (24) onto
the shafts for the support (15) fig 4.
Then place the left decorative cover
(28) and fix to the the bracket (15)
with Fig.5, along the the screw (32)
with washers (20) and nuts (21) and
tighten.
Now go through the same procedure
for the right side.
along with
16
NOTE: Once this stage of the
assembly has been completed, all of
the bolts fitted previously should be
retightened securely.
Insert the seat support (26) onto the
post sticking out of the tube (33) Fig.5.
Line up one of the height setting
holes, Fig.5, on the seat support and
release the knob then tighten the knob
(24) by turning it clockwise.
Position the backrest support (33) on
the main body (25), Fig.5. Insert screw
(31), along with washers (20) and
locknut (17), and tighten securely.
Take the leg support (27), fit the
spacer (30) on the inside of the
bushing for the leg support (27), Fig.5.
Fit it into the holes on the seat support
(33) by lining up the holes insert
screws (83) along with the washers
(84) and (5) and secure them.
Then place the pulley bracket (42)
and screw to the main body (25) with
the plate (45) Fig.6, place the screw
(31) with washers (20) and nuts (21)
and tighten.
Place the butterfly arms (34) and
(35) on the support shafts (25) fig 6.
Secure using the screws (44) along
with the washers (43) and tighten.
First insert the caps (41) in the top
leg tube- Place the bottoms foams
(40) of the leg support (36).
Finally, fit the caps (42) onto the
ends of the foam covers (40), Fig.6
along with the screws (43).
Place the footrest (46) on the
support tube (27) fig 6. Introduce the
screw (47) along the washers (5)
and tighten with the nut (16).
Publicité
