Virax VIPER M20+ Manuel D'utilisation page 11

● Ensure that the charger's ventilation slots remain unobstructed.
● Disconnect the charger from the power supply when recharging is completed
● Batteries may begin to leak if damaged or used under the wrong conditions.
● Avoid all contact between the battery and metal objects such as nails, screws, etc. when not in the charger or the press-fitting tool, in
order to prevent short circuiting.
● Never use a damaged charger. Never use the charger with a damaged cable or plug.
● Do not use a damaged battery. It must be replaced without delay.
● Do not dismantle the charger or the battery. Do not attempt to use the charger to recharge non-rechargeable batteries.
Press fitting machine
● Do not place your fingers inside the main jaw or the inserts.
Operation
View of the M20+ press fitting machine
4
1
2
3
●
Never operate the press fitting machine without inserts in the main jaw.
●
Always remove the battery from the machine when it is not in use. If left on the machine, the
battery will completely discharge and may be damaged.
Fitting the inserts into the main jaw
● Match the outer profile of the insert (4) with the inner profile of the half jaw and push the insert until it locks onto the jaw.
The main jaw will need to be opened slightly in order to fit the second insert.
Comment:
After fitting the inserts, visually check that they are correctly centred in the main jaw and aligned with one another.
Caution:
The main jaw has a powerful clamping action. Do not place your fingers between the jaws or the inserts.
Charging and installing batteries
Charging the battery
Tip: To preserve the battery life, we recommend that you make sure the battery is completely discharged before
recharging it.
● Connect the changer to the mains; the LED lights up red indicating that the charger is powered up.
● Insert battery 5 into its charger. Line up the four battery rails with the notches on the charger and push the battery to the
stop.
The left LED flashes green indicating that the battery is charging.
The right LED flashes yellow indicating that the battery has Lithium-Ion technology or remains on yellow indicating that
the battery has NiCd or NiMh technology.
7
8
6
5
IMPORTANT INFORMATION
N° Name
1 Locking pin.
2 Main jaw
3 Pressing rollers
4 Inserts
5 Battery
6 Latches
7 Trigger
8 Indicator LED
EN
11