Suspended Installation - EtiamPro EP60SQ60W30V1 Mode D'emploi

EP60SQ60W30V1/EP60SQ60W40V1/EP120R60W30V1/EP120R60W40V1
Framed Installation
For framed installation, use the EP60SQSFM/EP120SQSFM installation frame according to the
size of your panel light. The installation frame and other mounting accessories are sold
separately.
Check if the construction is sturdy enough to carry the weight of the panel light and frame, and
if the panel fits the mounting location. Make sure that all electrical cables are long enough for
the desired suspension height.
Provide suitable cabling from the mains and connect to the driver. See installation procedure
above.
Use the frame to take the mounting holes measurements (see mounting instructions above).
Drill the necessary mounting holes using the appropriate tools (not incl.). Insert a nylon plug
(not incl.) in each of the holes. Fix the frame to the roof using M4 screws (not incl.).
Slide the panel light into the frame and close the fame.

Suspended Installation

For suspended installation, use the EP60SQCAB suspension cable set to hang the panel light
from the ceiling. The cable set and other mounting accessories are sold separately.
Check if the construction is sturdy enough to carry the weight of the panel light, and if the
panel fits the mounting location. Make sure that all electrical cables are long enough for the
desired suspension height.
Provide suitable cabling from the mains and connect to the driver. See installation procedure
above.
V. 01 – 21/10/2019 6 ©Velleman nv