Using The Subwoofer; Power Indicator; Pre-Adjusting The Subwoofer Volume - Yamaha YST-FSW150 Mode D'emploi

Using the subwoofer

1
YST-FSW150
front panel
YST-FSW050
OFF/SYSTEM
front panel
POWER
OFF/SYSTEM ON
YST-FSW150
rear panel
INPUT SYSTEM
CONNECTOR
4
SYSTEM
CONNECTOR
YST-FSW050
rear panel

1 Power indicator

Lights up green while the unit is turned on.
2 POWER button
Press this button to the ON position to turn on
the power of the subwoofer. Press this button to
the OFF/SYSTEM position to turn off the
power of the subwoofer or to use the system
connection (see page 4).
3 VOLUME control
Adjusts the volume level. Turn the control
clockwise to increase the volume, and
counterclockwise to decrease the volume.
4 SYSTEM CONNECTOR terminal
Used for system connection. See "The system
connection" on page 4 for details.
POWER VOLUME
0 10
OFF/SYSTEM ON
2 3
POWER VOLUME
0 10
ON
VOLUME
0 10
5
INPUT
SYSTEM INPUT
CONNECTOR
5 INPUT terminal
Input terminal for line level signals from the
amplifier.
Pre-adjusting the subwoofer
volume
Before you use the subwoofer, first adjust the
volume balance between the subwoofer and the
front speakers according to the procedure below.
1.
Set the VOLUME control to minimum (0).
2.
Turn on the power of all the other
components.
3.
Press the POWER button to the ON
position.
Turn on the power switch of the connected
component when the subwoofer is
connected using the system connection.
4.
Play a source that contains low-frequency
sounds. Adjust the amplifier's volume
control to the desired level.
5.
Increase the volume gradually to adjust the
volume balance between the subwoofer
and the front speakers.
To enjoy natural bass sound, keep the subwoofer
volume at a level where it is barely
distinguishable from other speakers.
6.
Adjust the volume of the entire sound
system using the amplifier's volume control.
y Tip
It is recommended to set the VOLUME control
about in the middle position when using in a multi
channel home theater system.
VOLUME
0 10
5
En