Licence Notifi cation (optional)
is a trademark of SRS Labs, Inc. TruSurround
technology is incorporated under license from SRS Labs,
Inc.
LICENSE NOTICE
M a n u f a c t u r e d u n d e r l i c e n s e f r o m D o l b y
Laboratories.
TRADEMARK ACKNOWLEDGMENT
"Dolby" and the double-D symbol are trademarks of Dolby
Laboratories.
Inserting Batteries in the
Remote Control Handset
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
Note : Remove the battery from remote control handset when
it is not to be used for a long period. Otherwise it can be
damaged due to any leakage of batteries.
Remote range is approximately 7m/23ft.
01-[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_32875W_1059UK_10067832_50165295.indd 4
01-[GB]_MB36_MASQUE_HDIDTV-MPEG4_BRONZE8_32875W_1059UK_10067832_50165295.indd 4
Switching the TV On/Off
To Switch the TV On
• Connect the power cord to the 220-240V AC, 50
Hz.
• Press "
" switch. Then the standby LED lights
up.
• To switch on the TV from standby mode either:
• Press the "
" button, P/CH
button on the remote control.
• Press the -P/CH or P/CH+ button on the TV. The TV
will then switch on.
Note: If you switch on your TV via standby button on the
remote control, the programme/source that you were
watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
• Press the "
" button on the remote control or press
the "
" switch, so the TV will switch to standby
mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 4 -
/
or a numeric
19.03.2010 16:32:55
19.03.2010 16:32:55