Calibration Check; Menu - THEIS VISION 2N AUTOSLOPE ALIGN Instructions De Service

14. Calibration Check

Set up the laser leveller as described in point 1. (but
on an extremely well aligned tripod) and align it along
a traverse length of approximately 30 metres –
starting with the X axis, for example – and switch it
on.
At the end of the traverse length, make a mark at the
level of the laser beam. After this, rotate the laser unit
by 180° and make another mark. Then do the same
for the Y axis. If all the marks are on top of each other
or are only slightly apart (maximum of 2 mm),
adjustment is OK. If the marks are a long way apart,
you must get a specialist firm to check the equipment
and recalibrate it.

15. Menu

Information and settings
Switch on the laser
Press for five seconds
InFo INFO- display
e.g. 1.5 CPU (Program Version)
Sn. (Factory number, 6 digit)
h (Operating hours)
Next menu item
Fb CH9 EU Automatic channel selection or set manually
Select channel CH 1 – 16. (AUTO: Reserved for au-
to-matic selection) Wireless off: OFF
Activate frequency selection (press for 5 sec.)
Save and next menu item
61