Automatic Shut-Off - Cloer 5549 Notice D'utilisation

Basic safety instructions
·
The appliance is intended to be used in household only and using in:
– staff kitchen areas in shops, offices and other working
environments
– in farm houses
– by clients in hotels, motels and other residential type environments
EN
– on bed and breakfast type environments.
·
Have repairs of Cloer electronic appliances carried out only by
authorized Cloer specialist dealers or by the Cloer customer service.
Improper repairs can involve substantial dangers for the user.
Furthermore, this will void your warranty claims.
·
Only operate the appliance at household-usual power sockets. Check
if the mains voltage stated on the type plate is up to that of your power
supply network.
·
If the supply cord is damaged, it must be replaced by Cloer, its service
agent or similarly qualified persons in order to avoid a hazard.
Pull power plug of the power socket
·
– in case of a defect.
– if the appliance is not used for a longer time.
– before any cleaning.
Only pull at the plug, never at the feed cable.
·
Do not tighten the feed cable too tight as otherwise the appliance is
·
likely to tip over.
Do not stretch the feed cable over sharp edges.
·
Do not use the feed cable for carrying and protect it from heat (hotplate
/ open flame).
This appliance can be used by children aged from 8 years and above
and persons
with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision
·
or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
Cleaning and user maintenance shall not be made by children unless
they are older than 8 and supervised.
·
Keep the appliance and its cord out of reach of children less than 8
·
years.
Do not leave children unattended to ensure they do not play with the
appliance. (Children should be supervised to ensure that they do not
play with hte appliance)
This appliance is not intended for use by persons with reduced physical,
·
sensory or mental capabilities, or lack of experience and knowledge,
·
unless they have been given supervision or instruction concerning use
of the appliance by a person responsible of their safety.
·
Do not use the appliance in outdoor.
Protect your appliance from humidity (splash water / rain).
·
Let the appliance cool off before cleaning or stowing away.
This appliance should not be operated due to an external timer or
seperate remote control system.
Do not immerse the appliance in water.
Preparing for use
·
Remove all packaging elements and labels, but
not the rating plate.
·
Place the tea maker on a dry, level, non-slip
surface.
Before initial use
·
Please read these operating instructions
carefully before using the appliance for the first
time.
·
For hygienic reasons: Before using the appliance
for the first time, boil 2 pots of water.
·
Set the timer to level 2.
·
Switch off the tea maker after the water has run
through the first time.
·
Allow the appliance to cool at least 5 minutes
before allowing clear water to run through a
second time.
·
Note: In order to guarantee a high standard
of quality for your tea maker, your device was
tested during the quality control using water.
For this reason there may still be residual water
in the tank, the staining of which, due to the
water, cannot be avoided.
Safety instructions for using the
tea maker
·
Use the tea maker only for brewing tea. Do not
pour other liquids or foods into the tea maker.
·
Pour at least 4 cups, but no more than 8 cups of
water into the tank. Scalding may result from
water boiling over.
·
Do not immerse the tea maker in water.
Removing and Replacing the lid
·
To remove the lid from the water tank, turn it
anti-clockwise until you see the „Lock open"
symbol in the small, round window next to the
lid handle.
·
Now the lid can be removed.
·
To seal the lid onto the water tank, the „Lock
open" symbol must be visible in the window
next to the lid handle.
·
Now place the lid onto the water tank and turn
this clockwise until the „Lock closed" symbol is
visible.
·
The lid closes the water tank tightly.
Operation
·
Plug the power plug into the wall socket.
·
Open the lid of the tea maker by turning it
counterclockwise.
·
Use the teapot to pour the desired quantity of
water into the water tank. Pour the water slowly,
making sure that all water flows into the tank.
·
Do not fill the water tank with water past the
Max marking (8 cups).
·
Close the lid.
·
Place the teapot on the warming plate.
·
Remove the filter pot.
·
Place the funnel onto the filter. This makes it
easier to add the tea.
·
Place the desired amount of tea in the filter.
·
Use the quantity recommended by the tea
manufacturer.
·
Remove the funnel.
·
Insert the filter pot.
·
Always make sure that the lids are on the pots.
·
Use the timer (1 - 9 min) to set the desired
brewing time. You can change the time while
the tea is brewing.
·
Note: Switch the requested brewingtime on full
minutes (1, 2, 3, 4 etc...). Half minutes are not
possible.
·
Now switch on the appliance.
·
The blue LED will light up.
·
The water starts to boil.
CAUTION!
The lid must always remain closed
while the water is being heated.
·
After a few minutes the water will flow into the
filter pot.
·
At the end of the brewing time the tea flows
into the teapot.
·
Wait until all of the tea is in the teapot.
·
The warming plate switches on.
·
Wait 1 - 2 minutes before serving the tea to
allow the aroma to develop.
·
Now you can enjoy your tea.

Automatic shut-off

·
The Cloer tea maker is equipped with an
automatic shut-off function. The appliance
automatically shuts off approximately 2 hour
after the tea has finished flowing into the
teapot.
Timer Mode
· The Cloer tea machine is equipped with a timer
mode which enables you to set a specific time at
which, for example, your tea can begin brewing
whilst you are still in bed.
·
In order to activate the timer mode (deactivate),
the unit must be connected to the mains, but
does not have to be switched into brewing
process mode.
·
Hold the On/Off switch down for approx. 5
seconds. The LED behind the infusion jug will
flash once (for approx. 3 sec.). This signifies the
start of the operational mode.
·
Now connect an external timer switch between
the plug and socket and set the desired start
time.
·
Once the timer is switched on, the tea machine
begins the brewing process.
·
The LED flashes 3 times in quick succession,
signalling the timer mode.
·
The device remains in the timer mode until you
deactivate it. To do this, press the On/Off switch
for approx. 5 seconds.
·
Of course you can also brew your tea manually
in the timer mode (without using the timer
switch).
WARNING!
Deactivate the timer mode when
not in use. If this is not done, and
EN