Velleman CAMIP3 Notice D'emploi page 5

• Access from the Internet
You might need to connect to your camera on a computer other than yours. In this case, you can connect to the
camera by using the internet provided you modify the router configuration. Enable the RNAT function of the IP
sharing device:
o Many routers support VirtualServer. Forward the WAN 80 TCP port to the LAN IP address and port.
o You can also use the DMZ Host method. This method only supports one LAN device. If you have more than
one camera, use the above method.
• Dynamic Domain Name Access
Visit http://www.vipcam.cn, enter the serial number of the camera and the original password login. Enter a valid e-
mail address. Visit your camera by selecting system setting > network setting > dynamic domain name. Choose
DDNS supplier, enter your user name and password, and click apply. The camera will reboot. Make sure to open
the UDP port.
• Connecting to the Internet Via ADSL
This network framework is similar as your LAN. You may need to open the PPPoE service. With an open PPPoE,
use network cables and connect the camera to the PC network card directly. Run VilarWizard_CN.exe or enter the
camera IP address into the Internet Explorer browser. Select System Setting > Network Setting and enter your
user name and password in the PPPoE section.
Check both boxes and reboot your computer after clicking OK.
Start the DDNS service.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
CAMIP3_v2
Install ActiveX if necessary. Click Install to continue. Modify the Internet
Explorer security configuration if the window does not appear. ActiveX
cannot be downloaded without authorization until the Internet Explorer
security is properly configured.
Set the Internet Explorer security configuration as follows:
• Select Internet Options in the Tools menu.
• Click the Security tab.
• Select Custom Level and set up as on the left.
• Click OK to confirm.
In addition, the camera IP address can also be set as a trusted site.
• Select Internet Options in the Tools menu.
• Click the Security tab.
• Select Trusted Sites.
• Uncheck the √.
• Enter the camera IP address or URL.
• Click Add and then OK to confirm.
- 5 - VELLEMAN