The mobility scooter operates at 24 V and uses 2
12 V batteries connected in series. Never use both
batteries at the same time:
Batteries from different manufacturers
Batteries with different technologies
Batteries with different date codes
Tyres (if pneumatic tyres)
Attention
Contact the supplier in the event of a flat tyre.
The tyre pressure may not be more than 3.45 bar.
The pressure of the front tyres must be at least
2.0 bar.
The pressure of the rear tyres must be at least
2.5 bar.
Service and technical support
At least once a year have the mobility scooter checked
and serviced by your dealer. Preventive maintenance
ensures that the proper and correct functioning of all
moving parts is checked, as well as the electronics and
the condition of the batteries.
Repairs should only be performed by your dealer or
by Life & Mobility, and only original parts supplied by
Life & Mobility should be used for this.
Maintenance
EN28
Maintenance matrix
The following matrix indicates which parts should be
regularly checked. If a defect occurs, contact your
dealer to resolve this issue.
Part
Action
Battery charger
Check functioning
X
Housing
Clean with damp
cloth
Tyres
Check tyre
pressure
Check profile
depth (min. 1.6
mm)
Batteries
24hour charging
cycle
Mobility scooter
Servicing
Servicing by the dealer
The following items must be checked when being
serviced:
1. Check parts to determine whether they are broken.
If broken, the part must be replaced.
2. Check parts on rust. If required, touch up with metal
paint or replace .
3. Check moving parts on clearance. If the clearance
has a negative effect on operation, adjust or replace
the relevant part.
4. Check the bolt connections on tightening torque and
apply, if required, the overview below;
M5 screws > 6 Nm
M6 screws > 10 Nm
M8, M10 and M12 screws > 25 Nm
Maintenance
X
X
X
X
X
EN29