NOTE
The double-walled container contains coolant. Place the ice cream con-
tainer back in the freezer compartment if you hear the sound of moving
liquid when you agitate the container. If you do not hear anything, the
container is sufficiently cooled.
After the cooling process is completed, remove the ice cream container and
place it on a flat surface.
Mount the motor block into the recess on the cover. Ensure that both tabs snap
audibly into place in the two recesses on the cover.
Attach the stirrer on the drive shaft.
Place all the ingredients in the container. Do not exceed the capacity of 1.5 litres.
Place the cover together with the motor block onto the ice cream container. En-
sure that the locking tabs fit into the recesses and close the ice cream container
by turning the cover slightly in a clockwise direction.
Connect the appliance to a properly installed 220–240 V~, 50 Hz safety socket.
Press the
button to switch on the appliance.
The operating time 30 minutes flashes in the display.
You can set an operating time of up to 45 minutes.
Set the desired operating time. Press the TIME button to adjust the time in
5-minute increments (the timer counts up to 45 minutes, then starts again at 5
minutes).
NOTE
The preparation time for ice cream is approx. 30–40 minutes depending
on the amount.
Fill the ice cream container during operation via the filling opening in the cover.
After the time is up, disconnect the plug from the mains socket and remove the
cover with engine block and the stirrer.
Use a spatula to remove the ice cream from the container.
CAUTION!
Do not store finished ice cream in the ice cream container.
Use a suitable deep freeze container.
Clean the appliance components (container, stirrer, cover) carefully as described be-
low after preparing the ice cream.
DE
FR
NL
EN
53 of 58